Filter
Top Products
blinks every 0.5 or 1 seconds.
The screen is blank and it is
blinking.
z If you see the "TEST GOOD" message on the screen when you
pressing the MENU button, check the cable connection between
the LCD Display and the computer to ensure that the connector
is properly connected.
Problems related to Audio
Note
• Problems related to audio signals and their solutions are listed below.
Problems Solutions
No sound.
z
Ensure that the audio cable is firmly connected to both the
audio-in port on your LCD Display and the audio-out port on
your sound card.
(Refer to the Connecting the LCD Display )
z
Check the volume level.
The sound level is too low.
z Check the volume level.
z If the volume is still too low after turning the control to its
maximum, check the volume control on the computer sound
card or software program.
The sound is too high or too low.
z
Adjusts the Treble and Bass to the appropriate levels.
Problems related to the Remote Control
Note
• Problems related to the remote control and their solutions are listed.
Problems Solutions
The remote control buttons do not
respond.
z
Check the polarities (+/-) of the batteries.
z
Check if the batteries are empty.
z
Check if the power is on.
z
Check if the power cord is securely connected.
z
Check if a special fluorescent or neon lamp is on in the vicinity.
Problems related to MagicNet
Note
• Making a Bootable USB Flash Disk.
Problems Solutions
Making a Bootable USB Flash Disk
1. You can turn a common 512-MB or bigger USB storage media
into a bootable disk using a USB bootable disk creation tool.
(For example, the HP USB Disk Storage Format Tool)
2. Copies the OS ghost image and executables to your USB disk.
3. Enter the BIOS menu of your set by pressing the F2 key in the
BIOS logo screen. Then, enable the USB Boot First option by
selecting that option and pressing the Enter key in the Boot
menu.
4. Switch your set on while your USB disk is connected and boot
up in DOS mode.
5. Run C:\ghost.exe and choose Local
→
Partition
→
From Image
from the menu. Choose the ghost image to update your USB
disk with and choose the target disk.
6. When the ghost image update finishes, the set will be rebooted
automatically.