Filter
Top Products
4. Check if the scanning ratio of the video screen is set at 50Hz ~ 120 Hz.
(Do not exceed 85 Hz when using the maximum resolution.)
5. If you have problems in installing the adapter (video) driver, boot the computer in Safe Mode,
remove the Display Adapter at the "
Control Panel
→
System
→
Device Administrator
" and then
reboot the computer to reinstall the adapter (video) driver.
If problems repeatedly occur, contact an authorized service center.
Q & A
Question
Answer
How can I change the frequency? Frequency can be changed by reconfiguring the video card.
Note that video card support can vary, depending on the
version of the driver used. (Refer to the computer or the
video card manual for details.)
How can I adjust the resolution? Windows ME/XP/2000 : Set the resolution at the
Control
Panel
→
Display
→
Settings
.
* Contact the video card manufacturer for details.
How can I set the Power Saving
function?
Windows ME/XP/2000 : Set the function at BIOS-SETUP of
the computer or the screen saver. (Refer to
Windows/Computer Manual).
The monitor makes a sound when it is
turned on.
This is normal as some sound may be generated when the
metal case and the electromagnet, which are installed to
block any electromagnetic waves, interact with each other.
How can I clean the outer case/Picture
tube?
Disconnect the power cord and then clean the monitor with
a soft cloth, using either a cleaning solution or plain water.
Do not leave any remains of the detergent nor scratch the
case. Do not allow any water to go inside the monitor.
Self-Test Feature Check
Self-Test Feature Check | Warning Messages | Environment | Useful Tips
Your monitor provides a self test feature that allows you to check whether your monitor is
functioning properly.
Self-Test Feature Check
1. Turn off both your computer and the monitor.
2. Unplug the video cable from the back of the computer.
3. Turn on the monitor.
If the monitor is functioning properly, you will see a box in the illustration below.