Sanyo PLC 8810 Projector User Manual


  Open as PDF
of 3
 
Extron • System 4
xixi
xixi
xi
Switcher Series • User’s Manual • P/N 68-402-02 Rev. E
Configuration and ConnectionsSanyo Installation
Page 3
5. The Sanyo PLC Comm Adapter (26-467-01) has a 9-pin male connector that
accommodates the Comm Extension cable. The other end of the Comm Adapter
plugs into the projector’s RS-232C port.
6. Plug the 15-pin HD connector of the Projector Communications Extension cable
into the PJ Comm port on the System 4xi.
______ Secure all of the connector screws.
7. Plug the (4 or 5) BNC connectors from one end of the (user-supplied) RGBS/HV
cable onto the System 4xi output and those on the other end onto the matching
BNCs on the Sanyo PLC connector panel.
System 4xi Series – Sanyo PLC Projector Connections
Use the illustration below as a guide when connecting the System 4xi to a Sanyo
PLC Projector. Refer to Sanyo documentation to continue the installation.
____________ In a rack mount, do NOT allow the weight of the cables to be supported by the
System 4
xi
. See page 2-5 for cabling guidelines.
Special Note: _____ Certain PLC projectors may not come equipped with a 9-pin serial port
connector. In those situations, the Com adapter must be connected to Control
Port 2 using the projector’s special DIN to 9-pin serial adapter, as illustrated
below.
9-Pin Female
To projector's Control Port 2
Sanyo DIN to 9-pin adapter
To switcher's Projector Control port
9-Pin Female
9-Pin Male
9-Pin Male
Extron Com Adapter
26-467-01 "A"
or 26-489-01 "J"
A
R
AUDIO 1
ANALOG RGB
ANALOG RGB
CONTROL PORT 1USB 1
GBHV
RL
AUDIO 1VIDEO/Y
C/Cb(B-Y) Cr(R-Y) S-VIDEO
S-VIDEO
S-VIDEO
RL
AUDIO 2
CONTROL PORT 2
SERIAL PORTAC JACK
USB 2
RL
AUDIO OUT
RL
AUDIO 1VIDEO/Y
C/Cb(B-Y) Cr(R-Y)
RL
AUDIO 1VIDEO/Y
C/Cb(B-Y) Cr(R-Y)
RL
RGBHV 5 BNC
15-Pin
Male
9-Pin Female
9-Pin Male
9-Pin Male
ComAdapter
26-467-01 "A"
or 26-489-01 "J"
A
OUTPUT
PJ COMM
RS 232
AUDIO AUDIO AUDIO AUDIO AUDIO
H/HV
R/C G/Y BR/C G/Y B
V
INPUT 4
H/HV V
R/C G/Y B
INPUT 3
H/HV V
R/C G/Y B
INPUT 2
H/HV V
R/C G/Y B
INPUT 1
H/HV V
See Special Note below
 previous