Sanyo WTC500L Projector User Manual


  Open as PDF
of 89
 
20
Connecting to a Computer (Digital and Analog RGB)
Cables used for connection )(
*
=Cables are not supplied with this projector.)
• VGA Cable (Mini D-sub 15 pin) (One cable is supplied)*
• HDMI-DVI Cable * • Serial Control Cable *
• BNC Cable * • USB Cable *
HDMI-DVI
cable
USB
cable
USB port
USB
Unplug the power cords of both the projector and external
equipment from the AC outlet
before connecting cables.
✔Notes:
•USBcableconnectionisneededwhenoperatingthe
computerwiththeremotecontrol.
•WhentheStandbymodeissetto“Eco“intheSetting,
MONITOROUTandAUDIOOUTaredisabled.(p.56)
•Seepage84fororderingoptionalcables.
Monitor
Output
HDMI
DVI
Output
Monitor Output
BNC
cable
ANALOG
IN
Monitor
Input
G B R H/V V
Installation
MONITOR
OUT
CONTROL
PORT
Serial
Output
VGA
cable
VGA
cable
Serial
Control
Cable
✔Notes:
•WhenDVIsignalisconnectedtoHDMI
terminalwithHDMI-DVIcable,connectthe
soundsignaltoAUDIO1 andsetupSoundof
"HDMIsetup"to"AUDIO1".(p.58)
•Thisprojectorcanbeconnectedtothe
correspondingequipmentofDVIhowever
dependingontheequipmenttherearethe
casesitdoesnotoperatenormally;theimage
doesnotappearandthesoundisnotoutput.
 previous next