CT4xx Series Quick Guide Pg 2
What You Get
The CT Series Thermal Transfer printer comes packed in a protective carton.
Included in the carton are the following items :
• CT400 / CT410 Printer
• Quick Guide
• Driver / Manual CD ROM
• Power Module AC Power Cord
• Cleaning Solution & Cloth (Not for Export out of Singapore)
CT4xx Series Quick Guide Pg 11
6. If you are still unable to get printer output, try the Hex Dump as described in
Step 5 under the Parallel Interface troubleshooting. In this case, the printer
monitors its RS232C interface for incoming data.
7. From the Hex Dump, if you are seeing no extra 0D 0A (CR & LF)
characters, and are using BASIC, refer to the beginning of the Command
Code section. It provides hints for writing a SATO program in BASIC.
Error Signals
The 7-segment LED, Front Panel LED Indicators and Buzzer provide a
visual/audio indication of the type of error encountered.
LED Indicators Error Corrective
Dis-
play
LINE ERROR
Buzzer
Condition Action
0 ON 1 Beep
Flash Memory
error
Replace Flash ROM
1 Not Assigned
2 ON 1 Beep Motherboard error Replace PCB
3 ON 1Beep EEPROM error Replace EEPROM
4 ON 1 Beep Electrical Head Replace Print Head
5 Blink 3 Beeps Head not latched Latch Print Head
6 Blink 3 Beeps Out of Paper
1) Replenish paper
2) Route Paper thru sensor
7 Blink 3 Beeps Sensor error
1) Select correct sensor
2) Adjust sensor level
8 Blink 3 Beeps Cutter error Connect cutter
8. ON ON
Program
download error
Retry download
9 Blink 3 Beeps
Ribbon End (TT
mode only)
Replace ribbon
A ON 1 Beep
Receive buffer
overflow
1) Modify host SW
2) Select correct protocol
b ON 1 Beep
Parity error
(Serial I/F only)
Correct Parity Settings
c ON 1 Beep
Framing error
(Serial I/F only)
Correct data bit setting
d ON 1 Beep
Overrun error
(Serial I/F only)
Correct flow control
settings
E ON 1 Beep
LAN Time Out
Error
Replace LAN I/F
F 3 Beeps
Download Font /
Graphic Error
Correct data stream