Filter
Top Products
Basic Procedure
43
2
❒ Select one of the following settings or keys:
• [
Normal
]: normal paper
• [Thick]: thick paper, post cards, adhesive labels, translucent paper
• [OHP]: OHP transparencies
• [Duplex]: Use for copying onto the reverse side of paper that has been al-
ready copied onto. ⇒ P.49 “Copying onto the reverse side of paper”.
• [Duplex Thick]: Use for copying onto the reverse side of thick paper (105-
160g/m
2
, 28-43 lb) that has been copied onto. ⇒ P.49 “Copying onto the re-
verse side of paper”.
• [Custom]: Use to specify a custom sized. ⇒ P.45 “Copying onto custom size
paper with the bypass tray”.
❒ If the copy paper is bent, correct it before setting paper in the bypass tray. If
the bend is not corrected, a paper misfeed might occur.
❒ When you copy onto OHP transparencies, you can select whether a blank slip
sheet is inserted between OHP transparencies.
❒ When you set several sheets at a time, fan them to get air between them before
loading.
❒ If the copy paper is curled, gently roll it to remove the curl.
❒ When you copy onto OHP transparencies, insert them with the copy side up.
❒ Do not stack copy paper above the limit mark.
❒ When setting custom size paper, be sure to set the size after pressing the [Cus-
tom] key.
Copying onto standard size paper with the bypass tray
Note
❒ When you copy onto the reverse side of paper that has been already copied
onto, ⇒ P.49 “Copying onto the reverse side of paper”.
Gchyoh1e.eps