Filter
Top Products
• 11 •
What is CCA (COLD CRANKING AMPS)?
The current in amperes which a new fully charged battery can deliver for 30
seconds continuously without the terminal voltage falling below 7.2 volts (1.2
volts per cell), after it has been cooled to 0°F and held at that temperature.
This rating reects the ability of the battery to deliver engine starting currents
under winter conditions.
What is AMPERE-HOUR?
The unit of measurement of electrical capacity. A current of one ampere for
one hour implies the delivery or receipt of one ampere-hour of electricity.
Current multiplied by time in hours equals ampere-hours.
REPLACEMENT PARTS7.
Output Leads - 22-99-001824
Battery Cover - 37-99-006010
Paper Cover - 37-99-006020
Carrying Case - 22-99-001986
Paper Roll (1) - 49-99-000106
Cable Cover - 37-99-006724
REPLACING THE OUTPUT LEADS
Remove the screw in the backside bottom cover of the battery tester, and 1.
then remove the cover.
Disconnect the old cable connectors and insert the connectors of the new 2.
cable into the corresponding same color sockets. (Yellow Connector into
Yellow Socket; Red Connector into Red Socket; White Connector into
White Socket; Black Connector into Black Socket)
IMPORTANT3. : There is a small rib on the tester case, place the rst slot
of the rubber strain relief attached to the cable over this rib. There is also
a rib on the cover you removed, make sure that the rib is in the rst slot
of the strain relief when you replace the cover. Replace the cover and
tighten the screw. Do not over tighten.
LIMITED WARRANTY8.
SCHUMACHER ELECTRIC CORPORATION, 801 BUSINESS CENTER
DRIVE, MOUNT PROSPECT, IL 60056-2179, MAKES THIS LIMITED
WARRANTY TO THE ORIGINAL RETAIL PURCHASER OF THIS PRODUCT.
THIS LIMITED WARRANTY IS NOT TRANSFERABLE OR ASSIGNABLE.
Schumacher Electric Corporation (the “Manufacturer”) warrants this
battery tester for 1 year from the date of purchase at retail against
defective material or workmanship that may occur under normal use
and care.If your unit is not free from defective material or workmanship,
Manufacturer’s obligation under this warranty is solely to repair or
replace your product with a new or reconditioned unit at the option of
the Manufacturer. It is the obligation of the purchaser to forward the unit,
along with mailing charges prepaid to the Manufacturer or its authorized
representatives in order for repair or replacement to occur.