Filter
Top Products
• 9 •
TROUBLESHOOTING13.
PROBLEM POSSIBLE CAUSE REASON/SOLUTION
The Instant Power™ won’t
jump start my car.
Jump Start/USB Switch is not
turned ON.
Clips are not making a good
connection to the battery.
The Instant Power™ battery is
not charged.
The vehicle’s battery is
defective.
Turn ON the Jump Start/USB
Switch.
Check for poor connection to
battery and frame. Make sure
connection points are clean.
Rock clips back and forth for a
better connection.
Check the battery charge
status by pressing the button
on the front of the Instant
Power™. See DIGITAL
DISPLAY FUNCTIONS section
of this manual.
Have the battery checked.
The Instant Power™ won’t
power my 12V device.
The 12V device is not turned on.
The Instant Power™ battery is
not charged.
The 12V device draws more
than 15A or has a short circuit.
Turn on the 12V device.
Check the battery charge
status by pressing the button
on the front of the Instant
Power™. See DIGITAL
DISPLAY FUNCTIONS section
of this manual.
Disconnect the 12V device.
The internal breaker will
automatically reset after a
minute or two. Try the 12V
device again. If it happens
again, replace the 12V device.
The battery in the Instant
Power™ won’t hold a charge.
The battery is bad (will not
accept a charge).
Have the battery checked.