Filter
Top Products
• 6 •
The Instant Power™ light will turn on and illuminate your work area.4.
Press the Light Switch to the OFF position.5.
Charge the Instant Power™ as soon as possible after using the built-in light.6.
Using the Air Compressor10.6
RISK OF EXPLOSION.
Read the instructions of the product being inated before using the compressor.
Avoid overination, do not exceed the manufacturer’s recommended pressures.
Do not leave the air compressor unattended during use.
Ensure the battery clips are securely on the storage holders.1.
Remove the air compressor hose from the storage compartment in the back 2.
of the Instant Power™. Install adapters as necessary.
Attach the air compressor hose to the product or accessory to be inated.3.
Place the Compressor/Inator Switch in the COMPRESSOR position and inate 4.
the product.
When the product is inated to the proper air pressure (using the air compressor 5.
gauge) place the Compressor/Inator Switch in the OFF position and remove the hose.
Do not run for more than 10 minutes maximum at a time. Allow the Instant Power™ 6.
to cool down for 10 minutes before using again.
NOTE: To prevent overheating, the compressor has built-in thermal protection that
will turn the compressor off before it overheats. If the compressor shuts off, wait a few
minutes and it will automatically restart when the compressor cools.
NOTE: The air compressor is rated for 150 PSI.
Using the Inator10.7
RISK OF EXPLOSION.
Read instructions of the product being inated before using the inator. Avoid
overination, do not exceed the manufacturer’s recommended pressures. Do
not leave the inator unattended during use.
Ensure the battery clips are securely on the storage holders.1.
Attach the corrugated hose with end adapter to the high-ow inator outlet 2.
located near the Compressor/Inator switch on the back of the Instant Power™.
The main accessory adapter attached to the corrugated hose accommodates up to 4 3.
sizes. If another size is needed, an additional adapter can be attached to the end of
the main accessory adapter.
Insert the adapter into the product to be inated.4.
Push the Compressor/Inator switch to the INFLATOR position and inate the product.5.
When the product is inated to the desired level, push the Compressor/Inator switch 6.
to the OFF position and remove the adapter.
Using the Deator10.8
Ensure the battery clips are securely on the storage holders.1.
Attach the corrugated hose with the end adapter to the high-ow deator outlet, 2.
which is located on the side of the Instant Power™.
The main accessory adapter attached to the corrugated hose accommodates up to 4 3.
sizes. If another size is needed, an additional adapter can be attached to the end of
the main accessory adapter.
Insert the adapter into the item to be deated.4.
Push the Compressor/Inator switch to the INFLATOR position and deate the item.5.
When the product is deated to the desired level, push the Compressor/Inator 6.
switch to the OFF position and remove the adapter.
Before Using the Inverter10.9
Important Safety Instructions:
Keep the Instant Power™ well ventilated in order to properly disperse heat generated 1.
while it is in use. Make sure there are several inches of clearance around the top and
sides, and do not block the vents on the back of the Instant Power™.