Filter
Top Products
Pulsar XT.2 SAS Product Manual, Rev. B 31
7.5.4.1 Shock
a. Operating—normal
The drive, as installed for normal operation, shall operate e
rror free while subjected to intermittent shock not
exceeding:
• 1000 Gs at a maximum duration of 0.5ms (half sinewave)
Sh
ock may be applied in the X, Y, or Z axis. Shock is not to be repeated more than once every 2 seconds.
Note. This spec
ification does not cover connection issues that may result from testing at this level.
b. Non-operating
The limits of non-operating shock shall apply to all conditions of h
andling and transportation. This includes
both isolated drives and integrated drives.
The drive subjected to nonrepetitive sh
ock not exceeding the three values below, shall not exhibit device
damage or performance degradation.
• 1000 Gs at a maximum duration of 0.5ms (half sinewave)
Shock may be applied in the X, Y, or Z axis.
c. Packaged
Seagate finished drive bulk packs are designed and tested
to meet or exceed applicable ISTA and ASTM
standards. Volume finished drives will be shipped from Seagate factories on pallets to minimize freight
costs and ease material handling. Seagate finished drive bulk packs may be shipped individually. For less
than full shipments, instructions are printed on the bulk pack carton for minimum drive quantities and proper
drive placement.
Figure 9. Recommended mounting
Note. Image may not represent actual product, for reference only.