Filter
Top Products
Barracuda 9 Installation Guide, Rev. B 33
N drives
Terminating the drive
ST19171N drives are terminated with permanently mounted IC
active terminators. If you install one of these drives and it is not
on the end of the SCSI bus, disable the terminators by removing
the jumper from pins 15 and 16 of connector J2 (see Figure 6). If
you install the drive on the end of the SCSI bus, enable termina-
tion by installing a jumper on pins 15 and 16 of connector J2.
Figure 6. Terminating the drive
Disable SCSI terminator
Enable SCSI terminator (default)
SCSI I/O
Connector
Pin 1
J2
T
E
D
S
M
E
W
P
P
D
R
E
S
T
P
T
P
DC Power
Connector
J2
Drive
Front
J6
J1
J2 Jumper Type
(enlarged to
show detail)