Filter
Top Products
Barracuda 9FC Installation Guide, Rev. A 3
Always observe the following warnings and precautions:
• Perform all maintenance by following the procedures in this
manual.
• Follow all cautions and warnings in the procedures.
• Use sound safety practices when operating or repairing the
unit.
• Use caution when troubleshooting a unit that has voltages
present. Turn off power to the unit before servicing it.
• Ensure that the internal temperature of the rack or cabinet
does not exceed the limits defined for the drive when the drive
is mounted in an equipment rack or cabinet. When units are
stacked vertically, pay special attention to the top where tem-
peratures are usually highest.
• Follow the precautions listed above in “Electrostatic discharge
protection.”
• Do not remove any circuit boards from the drive chassis.
Return the entire drive for depot repair if any circuit board is
defective. Removal of circuit boards by personnel not perform-
ing depot repair will damage components and may void the
warranty.
As a component, the drive is designed to be installed and oper-
ated in accordance with UL1950, IEC950, CSA C22.2 950-M89,
VDE0805 and EN60950.
Seagate takes all reasonable steps to ensure that its products
are certifiable to currently accepted standards.
Typical applications of these disc drives include customer pack-
aging and subsystem design. Safety agencies conditionally cer-
tify component assemblies, such as the Barracuda disc drive,
based on their final acceptability in the end-use product. The