Filter
Top Products
Hawk 2LP Family Installation Guide, Rev. B 31
_____________________________________________________________________________________________________________
• Verify that all connections between the drive and the
host system are correctly installed. Most cables have
a contrasting color stripe indicating pin 1. Pin 1 on the
drive I/O connector and the DC power connector are
indicated in the figures in the Initial Set-up Informa-
tion section.
• Verify option select and drive ID select jumpers and
installation of terminator enable jumper where appli-
cable. See Drive Configuration section.
Do not power up the host system until the drive is
mounted and the system cover is replaced.
• Connect DC power connector to the drive.
• Replace the Host System cover.
• Turn on DC power.
• Boot the system from the floppy drive or from a
previously installed hard-drive if there is one.
• Proceed with drive setup of the new hard drive.