Filter
Top Products
• 9 •
BEFORE USING THE INVERTER14.
Important Safety Instructions:
Keep the 1150 well ventilated in order to properly disperse heat generated 14.1
while it is in use. Make sure there are several inches of clearance around
the top and sides and do not block the vents on the back of the 1150.
Makesurethe1150isnotclosetoanypotentialsourceofammable14.2
fumes, gases or clothing.
Keep the 1150 dry.14.3
DO NOT allow the 1150 to come into contact with rain or moisture.14.4
DO NOT operate the 1150 if you, the 1150, the device being operated or 14.5
any other surfaces that may come in contact with any power source are
wet. Water and many other liquids can conduct electricity, which may lead
to serious injury.
Do not place the 1150 on or near heating vents, radiators or other sources 14.6
of heat.
Do not place the 1150 in direct sunlight. The ideal air temperature for 14.7
operation is between 50° and 80°F.
Do not use inverter near open engine compartment where fumes or gases 14.8
may accumulate.
Do not modify the AC receptacles in any way.14.9
USING THE INVERTER 15.
It is important to know the continuous wattage of the device you plan to
use with the inverter. The Portable Power 1150 must be used with devices
drawing 400 watts or less. If the wattage is not marked on the device, use
only devices that draw less than 4 Amps of AC.
Devices like TVs, fans or electric motors require additional power to start
(commonly known as the “starting or peak power”). The Portable Power
1150 can supply a momentary surge in wattage; however even devices
rated less than the maximum 400 watts can exceed the inverters surge
capability and cause an automatic overload shutdown.
Makesurethedeviceyouareusingiscompatiblewithamodiedsine
wave inverter.
CAUTION: Always run a test to establish whether the inverter will operate
a particular piece of equipment or device.
NOTE: In the event of a power overload, the inverter is designed to auto-
matically shut down. This safety feature prevents damaging the inverter
while testing devices and equipment with the 400-watt range.
Note: If powering more than one device, start one device at a time to
avoid a power surge and/or inverter overload. The surge load of each de-
vice should not exceed the inverter’s Continuous Operation wattage rate.