Sharp AL-2060 Fax Machine User Manual


 
12
Operation Manual (for general information) (on the CD-ROM)
Explains the machine and how to use it as a copier. Also explains how to install the software that allows the machine
to be used as a printer and scanner for your computer.
The following information is contained in the operation manual for the machine :
Online Manual (on the CD-ROM)
This manual explains the procedures for using the machine as a printer and a scanner.
FINAL PREPARATIONS
CONNECTING OTHER DEVICES
If desired, an answering machine or external telephone can be connected to the machine through the telephone
jack, labeled "TEL," on the rear of the machine.
Connecting an answering machine to the machine allows you to receive both voice and fax messages when you
are out. To use this feature, first change the outgoing message of your answering machine, and then set the
reception mode of the machine to "A.M." (Answering Machine mode) when you go out.
Comments:
1. It is advisable to keep the length of the message under 10 seconds. If it is too long, you may have difficulty
receiving faxes sent by automatic dialing.
2. Your callers can even leave a voice message and send a fax message on the same call. Modify your outgoing
message to explain that this can be done by pressing their [START] key ( ) after leaving their voice message.
You can connect an extension phone to the machine to make and receive calls like any other extension phone on
your line. Even if you pick up the extension phone and hear a fax tone, the machine will automatically cut in and
take over the line. Note, however, if you also have a PC modem on the same line, you must turn on the Remote
Reception function, and deactivate the Fax Signal Receive function. See "SETTING UP THE MACHINE FOR
USE WITH A PC MODEM" (p.36) and "USING THE REMOTE RECEPTION FUNCTION" (p.37).
OPERATION MANUAL contents Page
CAUTIONS
3
PART NAMES 9
CHECKING PACKED COMPONENTS AND
ACCESSORIES
12
PREPARING THE MACHINE FOR
INSTALLATION
12
INSTALLING THE TD
(TONER/DEVELOPER) CARTRIDGE
14
POWER ON AND OFF 16
LOADING THE PAPER TRAY 19
BYPASS FEED (including special paper) 21
OPERATION MANUAL contents Page
CHANGING A TRAY'S PAPER SIZE
SETTING
23
MISFEED REMOVAL 78
TD (TONER/DEVELOPER) CARTRIDGE
REPLACEMENT
82
DRUM CARTRIDGE REPLACEMENT 84
CHECKING THE TOTAL COUNT AND
DRUM CARTRIDGE LIFE
86
CLEANING THE MACHINE 87
ABOUT SUPPLIES 90
The Remote Reception function is initially set to "ON".
Note