Filter
Top Products
48
GENERAL INFORMATION Copier trouble?
Self-diagnostic function
An automatic self-diagnostic function is built into the copier. Should the
copier malfunction, the self-diagnostic function will locate the problem and
stop the copier to prevent damage. An alphanumeric code will appear in the
copy quantity display.
Example
Should the copier completely stop and a letter and a number appear alternately,
contact your SHARP service center immediately.
COPIER TROUBLE?
Be sure to use only genuine SHARP parts and supplies.
Please contact your SHARP service center immediately if a problem persists
after checking the above.
A toner cartridge is not installed. Install a toner
cartridge. If "CH" is blinking even if a
cartridge is installed properly, contact your
SHARP service center immediately.
The side cover is open.
Close the front and side covers securely.
The toner cartridge must be replaced. See page
28, TONER CARTRIDGE REPLACEMENT.
A misfeed has occurred. See page 30,
MISFEED REMOVAL.
Connect the copier to a power outlet which is
not used for other electric appliances.
●
Is blinking in the copy
quantity display?
●
Is steadily lit in the copy
quantity display?
●
Is the indicator blinking?
●
Is the indicator blinking?
●
Is the same power outlet used for
the lighting fixture and the copier?
Problem Solution
Power is on but copying
is not possible.
Lighting fixture flickers.