Sharp AR-163 All in One Printer User Manual


 
63
OPTIONAL EQUIPMENT
Erase
This copier has an edge erase mode and a centre erase mode.
Edge erase can be used to eliminate shadow lines around the edges of
copies caused when thick paper or a book is used as an original.
Centre erase can be used to eliminate the shadow produced by the
bindings of bound documents.
Edge + centre erase can be used to eliminate shadow lines around the
edges of copies and to eliminate the shadow at the centre of copies.
The erase width can be set from 0 to 20 mm (0" to 1") in five steps using
user program No. 16. See page 35.
This feature cannot be used with the 2 in 1 or 4 in 1 feature.
1
Place the original on the original table and close the
platen cover.
If an optional SPF is installed, it can also be used for this feature.
2
Press the ERASE ( / ) key to select the desired
erase mode.
To select the EDGE + CENTRE ERASE mode, press the ERASE
( / ) key until both the EDGE ( ) and CENTRE
( ) indicators light up.
3
Check the copy paper size.
The bypass tray and any tray with non-standard size paper cannot be
used for this feature.
If an optional paper feed unit is installed, use the TRAY SELECT
( ) key to select the desired paper size.
ELECTRONIC SORTING KIT (AR-EB3)
A B
A B
A
A
A B
A B
Centre erase
Edge + Centre erase
Edge erase
Electronic sorting kit (AR-EB3)