Filter
Top Products
KEY OPERATOR PROGRAMS
11
Output Trays
If a job separator tray kit or a finisher is installed along with a facsimile expansion kit, this program can
be used to specify which output tray will be used to receive copies and which will be used to receive
prints.
When "OUTPUT TRAYS" is selected and the OK key is pressed, the following display will appear.
(Example: The following display is shown for a copier equipped with a facsimile expansion kit, and a job
separator tray kit.)
1. Use the and keys to select the desired pattern of output trays.
2. Press the OK key.
Offset Function
If the offset function is enabled, each set of copies will be stacked offset from the previous set in the
sort and group modes in the center tray of the copier or in the offset tray of a finisher. This program is
used to enable or disable the offset function for these trays respectively.
When "OFFSET FUNCTION" is selected and the OK key is pressed, the following display will appear.
1. Use the or key to enable or disable the offset function for the
center tray of the copier.
2. If a finisher is installed, use the key to select "OFFSET TRAY" and
use the or key to enable or disable the offset function for the offset
tray of the finisher.
3. Press the OK key.
OUTPUT TRAYS
PATTERN
1
FAX
COPY
PRINT
OFFSET FUNCTION
CENTER TRAY
OFFSET TRAY
OFFSET
ON
Ar-M208_keyope_sec.book 11 ページ ２００２年６月１２日 水曜日 午後３時４１分