Filter
Top Products
KEY OPERATOR PROGRAMS
14
Preheat Mode
Preheat mode functions to reduce the power consumption by lowering the temperature of the fusing
unit to a programmed level once a programmed length of time has elapsed without any copier operation
after the last copy of a run is made or power is turned on. The preheat mode will help lower the user's
electricity bill, reduce waste of natural resources, and cut down on environmental pollution. The
programmed time is set to the factory default of 15 minutes as shipped from the factory. The default
time can be changed optionally within the prescribed range of time. We suggest you set the most
appropriate time according to your usage pattern.
The interval can be set to 1, 2, 5, 10, 15, 30, 60, 120 or 240 minutes.
When "PREHEAT MODE" is selected and the OK key is pressed, the following display will appear.
1. Select the desired time interval using the and keys.
2. Press the OK key.
Time Out Setting
If a copy job is started while a print or fax job is being run, the print or fax job will be interrupted. This
program is used to adjust the time that elapses before the print or fax job resumes after the copy job is
completed. If a print or fax job is sent to this machine while a copy job is being run, printing of the print
or fax job will start when the programmed time elapses after the copy job is completed. The time can be
set to 0, 10, 30 or 60 seconds. If 0 is set, the print or fax job will resume immediately after a copy run
has finished. (A facsimile expansion kit must be installed to run a fax job.)
When "TIME OUT SETTING" is selected and the OK key is pressed, the following display will appear.
1. Select the desired time using the and keys.
2. Press the OK key.
PREHEAT MODE
15 min.
(1~240)
TIME OUT SETTING
30 sec.
(0~60)
Ar-M208_keyope_sec.book 14 ページ ２００２年６月１２日 水曜日 午後３時４１分