Open as PDF
CONFIGURING THE PRINTER DRIVER
After installing the printer driver, you must configure the printer driver settings appropriately for the
number of paper trays on the machine and the size of paper loaded in each tray.
Click the "start" button, click "Control
Panel", click "Printers and Other
Hardware", and then click "Printers and
In operating systems other than Windows XP, click
the "Start" button, select "Settings", and then click
Click the "SHARP AR-XXXX" printer
driver icon and select "Properties" from
the "File" menu.
If you are using Windows NT 4.0/2000/XP, go to
In Windows 95/98/Me, click the "Setup"
Click the "Configuration" tab and set the
printer configuration based on the
options that have been installed.
Set the printer configuration properly.
Otherwise, printing may not take place
Click the "Set Tray Status" button and
select the size of paper that is loaded in
Select a tray in the "Paper source" menu,
and select the size of paper loaded in that
tray from the "Set Paper Size" menu. Repeat
for each tray.
Click the "OK" button in the "Set Tray
Click the "OK" button in the printer
!!install_ar230270.book 13 ページ ２００４年２月１９日 木曜日 午後１時１７分