Filter
Top Products
21
• If you want to enter a cashier/server code before every transaction, please consult your authorized
SHARP dealer.
• For the display type selection of the cashier/server code, “Variant 1” has been preset. For the
selection of the “Variant 2”, consult your authorized SHARP dealer.
• The cashier/server can be changed during a transaction. Please consult your authorized SHARP
dealer.
The register will enter into the power save mode when no entries are performed based on the pre-programmed
time limit (by default, 30 minutes).
When the register goes to the power save mode, the operator and customer displays will turn off. This is
indicated by a decimal point at the left most position of the lower line. The register will return to normal operation
mode when any key is pressed or a mode is changed with the mode key. Please note when the register is
recovered by any key entry the initial key entry is ignored. After the recovery, you may start the key entries from
the beginning.
In the following examples, your register will go into an error state accompanied with a warning beep and a
corresponding error message. Clear the error state by pressing the
c
key and take proper action.
Please refer to the error message table on page 223.
• When you enter an over 32-digit number (entry limit overflow): Cancel the entry and re-enter a valid number.
• When you make an error in key operation: Clear the error and continue entries.
• When you make an entry beyond a programmed amount entry limit: Check to see if the entered amount is
correct. If it is correct, it be possible to make the entry in the MGR mode. Contact your manager.
• When an including-tax subtotal exceeds eight digits: Clear the subtotal by pressing the
c
key and press the
a
,
Å
thru
É
,
k
, thru , or
h
thru key to finalize the transaction.
CH9
CHK5
CHK2
Error warning
3
Power save mode
2
Note
‹‹
Cashier/server
code
To display the current cashier/server code
■ Sign-on
Variant 1 :
(Code is displayed.)
Variant 2 :
(Code is not displayed.)
■ Sign-off
Variant 1 / Variant 2 :
SERV
/
Cashier/server
code
‹‹
SERV
/
‹‹
SERV
/
‹‹
SERV
/
‹‹
SERV
/
Procedure