Filter
Top Products
Sending a Fax by Automatic Dialling
59
2. Sending
Documents
Automatic redialling
If you use automatic dialling (including Direct Keypad Dialling) and
the line is busy, the fax machine will automatically redial the number.
The fax machine is set at the factory to make 2 redialling attempts at
intervals of 5 minutes.
To stop automatic redialling, press the
CHANGEOVER
key to show
the telephone line status in the display (make sure that RECALL
MODE appears on the top line of the display and the number of the
receiving party appears on the bottom line to the right), and then press
the
STOP
key.
Memory Retransmission
If a line error or power failure occurs during any type of memory
transmission, your fax will automatically redial the number and
attempt to complete the transmission. Retransmission will begin from
the page which was being transmitted when the error occurred.
The fax machine will make 2 attempts at retransmission at an interval
of 5 minutes.
♦
To stop retransmission, press the
CHANGEOVER
key to show the
telephone line status in the display (make sure that RETRY MODE
appears on the top line of the display and the number of the receiv-
ing party appears on the bottom line to the right), and then press the
STOP
key.
♦
The numbering of pages retransmitted will begin from "1" again.
♦
If an error or power failure occurs during transmission of a cover
sheet, retransmission will not take place.
all-FO4700.book Page 59 Friday, October 8, 1999 11:10 AM