Filter
Top Products
E-16
Connecting to the Computer RGB Input (RGB 1, 2)/Output Terminals
You can connect your projector to a computer for easy projection of full-color computer images, and an external
monitor for simultaneous viewing.
2 !
1. Connecting to an IBM-PC (VGA, SVGA,
XGA, SXGA) Series computer—1,280
1,024 maximum resolution
Plug one end of the RGB signal cable into the RGB
INPUT terminal on the projector and the other end
into the RGB signal output terminal on the
computer, and secure the plugs by tightening the
thumb screws.
Notes:
• This connection is possible only when using a computer with a VGA/
SVGA/XGA/SXGA or Mac display output port.
• By using RGB INPUT 2 and PC CONTROL 2, another computer can
be connected to and operated with the projector.
COMPUTER RGB
IN 1 IN 2
ANALOG RGB OUT
1
IBM-PC (VGA,
SVGA, XGA, SXGA)
Series (computer)
RGB Signal
Output Socket
Rear view of the projector
RGB Signal
Input Socket
RGB Signal
Cable
(Supplied)
2. Connecting to a Macintosh Series
Computer
640
480, 832
624 or 1,024
768 resolution
! Set the proper switches on the supplied
adaptor.
• For 640 ן 480 resolution, set switches 1 and
2 to “ON” and 3, 4, 5 and 6 to “OFF”.
• For 832 ן 624 resolution, set switches 2 and
4 to “ON” and 1, 3, 5 and 6 to “OFF”.
• For 1,024 ן 768 resolution, set switches 2
and 3 to “ON” and 1, 4, 5 and 6 to “OFF”.
@ Connect the supplied Macintosh adaptor to the
RGB signal output terminal on your Macintosh
Series computer, as shown on the left, and
secure the plugs by tightening the thumb
screws.
# Firmly plug one end of the supplied RGB signal
cable into the RGB input terminal on the
projector and the other end to the Macintosh
adaptor on the computer, and secure the plugs
by tightening the thumb screws.
Notes:
• Be sure to use the supplied Macintosh adaptor.
• Be sure the switches on the adaptor are properly set.
• Once the adaptor is connected to a computer and the computer is
turned on, the display mode cannot be changed even if the switches
on the adaptor are reset.
• The supplied adaptor is only for use with H-SYNC and V-SYNC out-
put. When connecting a Macintosh Series computer that only outputs
C-SYNC, use a special C-SYNC output adaptor (sold separately).
Macintosh Adaptor (Supplied)
ANALOG RGB OUT
@
Macintosh Adaptor (Supplied)
RGB Signal
Output Socket
ON
↑
↓
OFF
Macintosh
#
RGB Signal
Cable
(Supplied)
ANALOG RGB OUT
Macintosh
COMPUTER RGB
IN 1 IN 2
RGB Signal
Output Socket
RGB Signal
Input Socket
Rear view of the projector