Filter
Top Products
Setting Up and Using OpenLCR
25
2. Setting Up
OpenLCR
3 If the display shows the alternating
messages at right, press the number
keys to enter your fax/phone number,
including the area code (the number
must be 10 digits long). When finished,
press .
(If the message at right doesn’t appear,
this step is not necessary.)
4 Follow the instructions you hear.
♦ If you are on a pulse dial line, press before pressing the number keys
to respond. (This makes your fax temporarily issue tone signals when you
press the number keys.)
♦ When registration is completed, your fax machine will receive the rate data
from OpenLCR. This will last one or two minutes. When downloading is
completed, the display will briefly show DOWNLOAD OK!! and then revert
to the date and time.
♦ OpenLCR will also program the date and time and your fax number in your
fax machine.
START/MEMORY
Registering through OpenLCR’s Web site
You can also register at OpenLCR’s Web site, www.OpenLCR.com. After
registering you will need to receive the rate data manually (service is not
activated until your fax receives the rate data). See Downloading (receiving)
the rate data manually on the following page.
Important!
Be sure that you enter your correct
area code and fax number. If not,
your fax may not dial the correct
number to connect to OpenLCR.
The rate data that you receive is based
on the address you provide when
registering with OpenLCR. If you move,
the rate data will not be correct for your
new location. In this case, repeat the
registration procedure to give
OpenLCR your new address.
If you move, you
must re-register!
SET OWN NUMBER
10 DIGITS