Filter
Top Products
-48
Using the “Options1” Menu
Menu operation
Page 42
44
44
4
Keystone Correction
When the image is projected either from the top or from
the bottom towards the screen at an angle, the image be-
comes distorted trapezoidally. The function for correct-
ing trapezoidal distortion is called Keystone Correction.
Auto Keystone Correction
Set “Auto Keystone” on the “Options1” screen menu
to “On”.
Manual Keystone Correction
Set “Auto Keystone” on the “Options1” screen menu to
“Off”, and select “Keystone”, then adjust with the slide bar.
Manual Correction
Note
•
The Keystone Correction can be adjusted up to an
angle of approximately ±12 degrees with the “Auto
Keystone” and up to an angle of approximately ±40
degrees with the manual “Keystone”.
(when “Resize” is set to “Normal”)
•
When the screen is slanting or the image is deterio-
rated, set “Auto Keystone” to “Off”.
•
When adjusting the keystone or when “Auto Keystone”
is set to “On”, “Image Shift” is auto matically set to “0”.
Note
• You can also use ECO+QUIET button on the re-
mote control or on the projector to switch the
Eco+Quiet Mode. (See page 36.)
Selectable items
Logo
Blue
None
Description
SHARP default image
Blue screen
Black screen
Description
All On-screen Displays are displayed.
• INPUT mode/VOLUME/AV MUTE/
FREEZE/AUTO SYNC/MAGNIFY/ “An
invalid button has been pressed.” are
not displayed.
• “All buttons on Projector are locked.”
is displayed when
STANDBY/ON is
pressed while the Keylock function is
active.
Selectable items
On
Off
55
55
5
Setting On-screen Display
This function allows you to turn the on-screen
messages on or off.
66
66
6
Selecting a Startup and
Background Image
77
77
7
Eco+Quiet Mode Setting
||
||
| button
\ \
\ \
\ button
Description
The projector automatically enters the
standby mode when no input signal is
detected for 15 minutes or longer.
The Auto Power Off function will be
disabled.
Selectable items
On
Off
88
88
8
Auto Power Off Function
Note
• When the Auto Power Off function is set to “On”,
5 minutes before the projector enters the
standby mode, the message “Enter STANDBY
mode in X min.” will appear on the screen to
indicate the remaining minutes.
Brightness
Approx. 80%
100%
Selectable
items
On
Off
Fan
Sound
Low
Normal
Lamp life
Approx.
3,000
hours
Approx.
2,000
hours