Filter
Top Products
Series 24-HP Instruction Manual Chapter 3 Operation
IM-24-HP 3-1
Chapter 3 Operating Instructions
After installing the Innova-Mass Vortex Flow Meter, you are
ready to begin operation. The sections in this chapter explain the
display/keypad commands, meter start-up and programming. The
meter is ready to operate at start up without any special pro-
gramming. To enter parameters and system settings unique to
your operation, see the following pages for instructions on using
the setup menus.
Flow Meter Display/Keypad
The flow meter’s digital electronics allow you to set, adjust and
monitor system parameters and performance. A full range of
commands are available through the display/keypad. The LCD
display gives 2 x 16 characters for flow monitoring and pro-
gramming. The six push-buttons can be operated with the enclo-
sure cover removed. Or, the explosion-proof cover can remain
in place and the keypad operated with a hand-held magnet posi-
tioned at the side of the enclosure as shown in the illustration at
the left.
Figure 3-1. Flow Meter Display/Keypad
From the Run Mode, the
ENTER
key allows
access to the Setup Menus (through a
password screen). Within the Setup Menus,
pressing
ENTER
activates the current field.
To set new parameters, press the
ENTER
key
until an underline cursor appears. Use the
keys to select new parameters.
Press
ENTER
to continue. (If change is not
alllowed,
ENTER
has no effect.) All outputs
are disabled when using the Setup Menus.
The
keys advance through each screen
of the current menu. When changing a system
parameter, all
keys are available to enter
new parameters.
The
EXIT
key is active within the Setup Menus.
When using a Setup Menu,
EXIT
returns you to the
Run Mode. If you are changing a parameter and
make a mistake,
EXIT
allows you to start over.
Display/Keypad
Commands
EXIT
ENTER
Sierra
INSTRUMENTS
Innova-Mass™
VorTek
Instruments,
LLC
Pro-V
TM