Filter
Top Products
7
2. At the Windows NT Setup screen, press F6 to
specify and add the driver.
3. Press S, select Other, then press Enter.
4. Insert the driver diskette and press Enter.
5. Select Silicon Image SiI 3114 ... Controller for
Windows NT 4.0 and 2000, and press Enter.
6. Press Enter to continue and follow on-screen
instructions to complete Windows NT4.0
installation.
For Existing Windows NT4.0 Installation
1. Install the board and boot up Windows NT4.0.
2. Double click My Computer/Control Panel/SCSI
Adapters, then click the Drivers tab.
3. Click Add … then Have Disk ....
4. Insert the driver CD, type in D:, then click OK.
(Assuming D: is your CD-ROM drive)
5. Highlight Silicon Image SiI 3114 ... Controller and
click OK.
6. Click OK, remove the driver CD and restart NT to
complete the driver installation.
Verify Proper Installation for Windows NT4.0
1. Double click My Computer/Control Panel/SCSI
Adapters.
2. Highlight Silicon Image SiI 3114 ... Controller from
SCSI Adapters listing and click Properties. A
message This device is working properly is displayed
in the dialog box, the driver has been correctly
installed.