Filter
Top Products
9
Windows XP/Server 2003 Driver Installation
A new installation of Windows XP/Server 2003 requires
a floppy disk for the driver installation. To make this
floppy disk, copy the contents of the Floppy folder,
found on the driver CD, onto a blank floppy disk then
follow the directions below.
For New Windows XP/Server 2003 Installation
1. Install the board and follow Microsoft procedures
to install Windows accordingly.
2. Restart your system when prompted by Windows'
installation.
3. At the Windows Setup screen, press F6 to install the
driver.
4. Insert the driver diskette. Press S then press Enter.
5. Select Silicon Image SiI 3114 ... for Windows
XP/Server 2003, then press Enter.
6. Press Enter to continue and follow on-screen
instructions to complete Windows installation.
Note: If a Hardware Installation warning pops up,
click Yes. Our driver has been thoroughly tested in
Windows for stability.
For Existing Windows XP/Server 2003 Installation
1. Install the board and boot up Windows.
2. At the Found New Hardware Wizard, insert the
driver CD, select Install the software automatically
(Recommended), then click Next.
3. Accept the selected driver, then click Next.