Filter
Top Products
3
Hardware Installation
General instructions for installing the card are provided
below. Since the design of notebook computers may
vary, refer to your system’s reference manual for further
information, if needed.
1. Power off your notebook computer and any other
connected peripheral devices.
2. Insert the PC Card into the CardBus Type II slot of
your notebook computer with its 68-pin connector
facing the slot. Make sure it is inserted all the way
in for a solid connection.
3. Power on your notebook computer.
Software Installation
This section provides information on how to install the
FireWire 800 CardBus DV-Kit software.
Windows 2000
Windows 2000 automatically installs it's built-in FireWire
400 driver for the FireWire 800 CardBus DV-Kit. To get the
full speed out of this controller, install the Firewire 800
driver using the directions below.
1. Insert the driver CD. Click Start, then click Run.
Type D:\setup.exe, click OK. (Change D: to match
your CD-ROM drive letter)
2. At the Welcome screen, click Next.
3. At the License Agreement screen, click Yes.
4. Type in your customer information, then click Next.
5. At the Destination Location screen, click Next.
6. Select Complete, then click Next.
7. At the Select Program Folder screen, click Next.