Filter
Top Products
SVP 450 PLUS - SVD 500 PLUS
14
CON 49
STORED
MAIN SETTINGS
MEMO NOR DATA
INSTALL. MENU
CON 49
INSTALL MODE
Before adj. REGISTRATIONS
be sure the following
items have been checked :
1 Mechanical centering of
the projector and tubes
2 Lens focus adjustment
All peaking, hue, colour, brightness and contrast values
are now stored.
To recall the SET adjustment, press , no message is
displayed.
To change the USER adjustment: change according to
the peaking, hue, colour, brightness and contrast required.
To store a set of adjustments that will be used by the
projector at switching on: use peaking, hue, colour
brightness and contarst value to reach a personalized
adjustment.
To store the adjustments carried out, press the MEMO
menu.
The user setup is stored only when the MEMO button
is pressed and one of the adjustments is switched
on (a small window appears showing a digit that
disappears in a few seconds).
To change the video picture adjustments.
For instance, to change the contrast value, press for 1
second only, the screen displays the following indication:
In order to prevent the final user from gaining access and
carrying out unnecessary installation adjustments, the
projector is equipped with a special protection key.
Observe the following procedure to unlock it and gain
access to the installation mode.
Press the button • • • for 2 seconds. The following menu
appears:
Press the arrows to select MENU INSTALL.
Press the button EXIT seven times, until the following
menu is displayed:
Increase or decrease the value by means of the arrows
until the desired value is reached.
To store the new value within the USER adjustments,
press the button MEMO, the remote control shows the
following:
Press ESC to let the message disappear or wait 4 seconds
and it will disappear on its own.
3.19 Installation menu
The adjustments described in this paragraph must
be carried out by qualified personnel. Any
adjustments incorrectly done can cause deterioration
in picture quality.
3.20 How to enter the installation
mode
It is only possible in the installation mode to change
deflection, adjust the white balance, turn ON/OFF the
comb. filter, choose the type of installation and store a
setting in the memory banks.
Besides carrying out all user adjustments, with the same
RC 3100 user remote control it is also possible to carry
out all adjustments for a perfect installation and a proper
setting of relevant parameters.
INSTALL MODE
DEFLECTION
OPTIONS
PATTERN SELECT
VIDEO SETUP
Press the button ENTER.
The following menu appears:
Use the arrows to select each single menu item. Each
line corresponds to a sub-menu.
Note:
The following menus operate only in the installation
mode: deflection; video param.; options and test
patterns. Further details about these menus can
be found in the section of this manual relevant to
installation.
Once the installation procedure is through, switch off the
projector to exit the installation mode, finally re-start the
protection key.