Simaudio 320 S Power Supply User Manual


 
MOON 320S Power Supply
Operating the 320S
Since your MOON 310LP Phono Preamplifier is not equipped with its own on/off power switch, powering it on and off is
accomplished via the MOON 320S Power Supply’s on/off switch, located on the rear panel.
We recommend that you leave your MOON 320S Power Supply powered up at all times to maintain optimal sonic
performance. In the event that you plan to be away from your home for a few days, powering off the MOON 320S may not
be a bad idea. Once fully “broken-in”, please keep in mind that both your MOON 320S and MOON 310LP will require
several hours of playing time before they reach peak performance again.
Powering up your MOON 320S for the first time
Prior to making the AC connection for the first time, make sure that every cable is properly connected to avoid any problems.
Once the 320S is connected to an AC source you may power it up by flicking the main rocker switch labeled “POWER” to the
‘1’ (on) position. The blue LEDs on the front panel of both the MOON 320S and MOON 310LP will illuminate at the same
time.
On and Off Sequence
To avoid having any annoying noises (ie. “thumps” and “pops”) emanate from your speakers when powering your 320S on or
off, you should
1) Always power up your 320S before powering up your preamplifier and/or integrated amplifier.
2) Always power down your 320S after powering down your preamplifier and/or integrated amplifier.
When you power down the MOON 320S, the blue LEDs on both units will remain illuminated for up to 10 seconds; this is
normal and is the result of the large amount of storage capacitance found in the MOON 320S Power Supply.
____________________________________________________________________________________
Operating the 320S 9