Sony BW-RS101 Computer Drive User Manual


 
15
Setting Functions/SCSI ID
Chapter 2 Getting Started
Setting Functions/SCSI ID
BW-RS101 Function Settings
Use the function switches A to P on the rear panel of the unit to set the unit’s
functions and SCSI ID according to the host computer and software that you are
using. Make sure that the unit is off before setting the switches.
:Factory Settings
BW-RS101 Function switch settings
Note
Reserved*
Do not set any of the reserved switches to 1, changing the reserved switches
setting may cause the unit failure.
Switch Function 1 0
A Terminator Power Supply POWER to the
terminator enabled
Supply POWER to the
terminator disabled
B Force CAV All operations are
performed in CAV
seek mode.
Optimum mode
enabled. (Automatic
CAV/CLV selection)
C Background format
control
Background Format
mode enabled
Background Format
mode disabled
D Reserved*
E Reserved*
F Inhibit Verify Do not verify writes Verify write operations
G Write Cache control Write caching disabled Write caching enabled
H Device Type Report 00H as device
type (Direct Access
device)
Report 07H as device
type (Optical Memory
device)
I SCSI Parity Check SCSI parity check
enabled
SCSI parity check
disabled
J Reserved*
K Reserved*
L Reserved*
M SCSI ID 3 To set the SCSI ID, see “BW-RS101 SCSI ID
Settings” on page 17.
N SCSI ID 2
O SCSI ID 1
P SCSI ID 0
ABCDFFGH I JKLMNOP
I
O