Filter
Top Products
Back Back to Top Print
IC Recorder
ICD-PX440
Messages list
Follow the instructions below if a message appears on the display.
HOLD. Slide HOLD Switch to Activate.
All the button operations are disabled because the IC recorder is in the HOLD status to prevent unintentional
operations. Slide the HOLD
・
POWER ON/OFF switch towards the center to release the IC recorder from the HOLD
status.
(See “Releasing the HOLD function”)
Low Battery Level
You cannot format the memory or erase all the files in a folder because of insufficient battery power. Replace the old
LR03 (size AAA) alkaline batteries with new ones.
(See “Inserting batteries”)
Low Battery
The batteries are exhausted. Replace the old LR03 (size AAA) alkaline batteries with new ones.
(See “Inserting batteries”)
Low Battery to Update
The software update cannot be done because of the insufficient battery power.
Replace the old LR03 (size AAA) alkaline batteries with new ones.
(See “Inserting batteries”)
Memory Card Error
An error occurred while a memory card was being inserted into the memory card slot. Remove and try inserting it
again. If this message persists, use a new memory card.
Memory Card Not Supported
A memory card that the IC recorder does not support is inserted.
(See “About compatible memory cards.”)
Memory Card Locked
The memory card is write-protected. A write-protected memory card cannot be used with the IC recorder.
Read Only Memory Card
Help Guide
Troubleshooting
280