Filter
Top Products
Location and Function of Parts and Controls
GB
8
A POWER switch and indicator
Each time you press the switch, the power is turned on
or off. When the power is turned on, the indicator
lights in green.
B Tally lamp
You can check the status of the monitor that the signal
is input by the color.
The lamp lights in red or green by signals from the
equipment connected to the REMOTE connector.
When red and green signals are input, the lamp lights
in amber.
The pins on the REMOTE connector are used to
control the tally lamp.
For details, see page 9.
C Aspect select button and indicator (LMD-
7220W only)
Sets the aspect ratio of the picture. When the button is
pressed, the aspect ratio of the picture is set to 4
:3 and
the indicator lights.
D CONTRAST control
Turn this control clockwise to make the contrast
higher or counterclockwise to make it lower.
E PHASE control
This control is effective only for the NTSC color
system.
Turn it clockwise to make the skin tones greenish or
counterclockwise to make them purplish.
F BRIGHT (brightness) control
Turn this control clockwise to increase the brightness
or counterclockwise to decrease it.
Indistinctness of the picture when the viewing angle of
the monitor is adjusted may be compensated by
adjusting the brightness.
G CHROMA control
Turn this control clockwise to increase the color
intensity or counterclockwise to decrease it.
Adjusting the viewing angle
You can adjust the viewing angle of LMD-5320/7220W
up to 10 degrees upward or downward and LMD-4420
up to 8 degrees upward or 10 degrees downward.
Adjusting upward
Adjusting downward
NOTE
When the AC adaptor is attached to the monitor and the
angle is adjusted, the AC adaptor may be touched to the
equipment set to upper or lower. Remove the AC
adaptor holder from the monitor.
Press the center top.
Press the center bottom.