Filter
Top Products
1-2PCGA-DSD5/DSM5 (UC)
Confidential
(END)
1-2. Attention of i.LINK
The i.LINK compatible unit connected to this set is not recognized. Or,
the message such as “Operation is disabled, as DV unit is not con-
nected or the power is not turned on” is displayed.
t Disconnect the i.LINK cable once, and reconnect it. For further informa-
tion, see “Connecting i.LINK unit” of “Data transfer to i.LINK unit” in the
“Extend” of the Online Manual for this set.
The unit connected to the i.LINK connector on the docking station does
not operate normally.
t Use the i.LINK connector on this set.
The operation of i.LINK compatible unit connected to this set stopped.
t Finish the operation of the i.LINK compatible unit first, when removing
the docking station during the connection of i.LINK compatible unit.
The message “Recording to DV unit failed. Retry after checking the DV
unit for power supply and connection state” is displayed during the
recording on the tape using the “DVgate” software.
t Check if the power and connection cables are connected correctly to
the DV unit. Continuous recording may cause a recording failure even if
the unit is connected correctly. In such a case, restart this set after exit-
ing all of the software.
To use the set in more comfortable environment, it is recommended to
extend the memory. For further information, see “Extending the memory”
(page 109).
The frames drop during the use of “DVgate” software.
t The frames may drop depending on the operating condition. In such a
case, extend the memory. For further information, see “Extending the
memory” (page 109).