Filter
Top Products
88 (EN)
Control Panel
1 Remote control detector
Receives the beam from the Remote Commander.
2 u (standby) switch/u (standby) indicator
Press to turn the monitor on. Press again to go back to
the standby mode.
The u (standby) indicator lights up in red in the
standby mode.
When the u indicator flashes, see “Self-diagnosis
Function” on page 31(EN).
3 Power indicator
Lights up when the monitor is turned on.
Flashes in the power saving mode.
For details on the power saving mode, see “Turning Off the
Power Automatically When There Is No Input Signal (Power
Saving Function)” on page 30(EN).
4 CTRL (control) button
To operate the buttons on the control panel, first press
this button. Then the buttons light up or flash that show
they can be operated. Press again to deactivate them.
Note
The buttons (except for u (standby) switch 2) on the
control panel do not function if you do not press the
CTRL button first.
5 Y/C button
Select the signal input from the Y/C IN jack in the
LINE connectors.
6 LINE button
Select the signal input from the VIDEO IN connector
in the LINE connectors.
7 RGB2 button
Select the signal input from the RGB2 connectors.
8 YUV button
Select the component signal input from the RGB1
connectors.
9 RGB1 button
Select the RGB signal input from the RGB1
connectors.
0 ENT (enter) button
Press to select the desired item in a menu.
!¡ >/. buttons
Press to move the cursor (z) to an item or to adjust
value in a menu.
!™ MENU button
Press to make the menu appear.
!£ VOL (volume) +/– buttons
Press the + button to increase the volume, or the –
button to decrease the volume.
Location and Function of Parts and Controls
VOL – VOL + MENU ENT RGB1 YUV RGB2 LINE Y/C CTRL
.>
u
!£ !™ !¡ 0 98765 4 32 1