Filter
Top Products
12 (GB)
Installing batteries
Insert two size AA (R6) batteries in correct polarity.
e
E
E
e
• In normal operation, batteries will last up to half a
year. If the Remote Commander does not operate
properly, the batteries might be exhausted. Replace
them with new ones.
• To avoid damage from possible battery leakage,
remove the batteries if you do not plan to use the
Remote Commander for a fairly long time.
When the Remote Commander does not work
Check that the 1 indicator lights up. The Remote
Commander operates the monitor only when the
monitor is turned on, or it is in the standby mode.
Note
If you connect the cable to the CONTROL S IN jack
on the side of the monitor, you cannot operate the
monitor with the Remote Commander.
Location and Function of Parts and Controls / Installation
Installation
Using the Retractable Feet
This section describes the installation arrangements
for installing the projector.
1 Pull out the knobs and pull down the retractable
feet.
2 Turn the retractable feet outward.
3 Push in the retractable feet and lock.
To fix the retractable feet
When the unit is installed on the floor, be sure to fix
the retractable feet.
Install the foot support brackets as illustrated below.
Be sure to
install the
negative <
–
end first.