Filter
Top Products
Installing the S-AIT Tape Drive Unit / Installing Device Drivers
18
Installing the S-AIT Tape
Drive Unit
The S-AIT Tape Drive Unit weights about 7 kg (15.4 lb.)
and has the following dimensions. Make sure that the
surface where you will install the S-AIT Tape Drive Unit
is appropriate before installing the unit.
Note
Install the S-AIT Tape Drive Unit on a horizontal surface
near an AC power outlet. Make sure that you leave gap
of about 150 mm (5.9 in.) behind the rear of the unit to
allow air to circulate.
Recommended positioning of the unit
• Always position the unit horizontally.
• Away from moving air, such as fans, open windows, or
air conditioners.
• Away from devices such as facsimiles to avoid toner
and paper dust.
The S-AIT Tape Drive Unit should not be stacked. Do
not place anything on top of the unit.
Connecting the Power
Cable
1
Verify the power cable plug to make sure that it
matches the AC IN connector receptacle.
2
Make sure that the electrical outlet you use to
connect the unit is properly grounded.
3
Connect one end of the power cable to the AC IN
connector and the other end to the power outlet.
Note
If the S-AIT drive does not come with a power
cable, make sure that you connect a power cable
appropriate for your country to this connector.
Installing Device Drivers
A device driver is host firmware that allows the S-AIT
Tape Drive Unit to interact with a variety of hosts.
If your software requires it, install the appropriate device
driver for your system from the supplied CD-ROM.
Refer to the instructions on the CD-ROM to install
device drivers.
The latest device drivers and documentation for the S-
AIT Tape Drive Units are available online. Contact your
dealer for details.
86 mm (3.4 in.)
370 mm (14.6 in.)
210 mm
(8.3 in.)
50 mm (2.0 in.)
210 mm (8.3 in.)
150 mm
(5.9 in.)
370 mm (14.6 in.)
50 mm (2.0 in.)
Rear
Front
AC Power