Filter
Top Products
the Minolta flash unit please refer to the corre-
sponding operating instructions.
If the flash button is not kept depressed during
shooting, then the flash light of the controller
does not contribute to the exposure of the sub-
ject, i.e. “Ratio” mode is not executed.
“Ratio” mode with two slave flash units:
In “Ratio” mode with two slave units the light out-
put of the two flashes is controlled by the controller
on the camera in a 1/3 to 2/3 ratio. The light output
share assigned to each slave is adjusted on the
individual mecablitz. 1/3 is indicated as “rA1” and
2/3 as “rA2” on the mecablitz display.
Setting procedure for the mecablitz 54 MZ-...,
70 MZ-... and 76 MZ-5 digi
Initialisa
tion:
Attach the SCA 3302 adapter to the mecablitz (or
the controller on the 70 MZ-... and 76 MZ-5 digi)
and mount on the camera. Switch on the camera
and the mecablitz. Adjust the camera to controller
mode (refer to the operating instructions for the
given camera). Set the required remote address
and light output share on the mecablitz. The meca-
blitz display will indicate SL for slave mode. Press
the “Mode” button on the mecablitz until TTL flas-
hes on the display. Then turn the setting disk on the
mecablitz and adjust the required remote address
and light output ratio.
Example:
The remote address 2 “Ad2” and a 2/3 light output
ratio “rA2” are to be adjusted.
☞
38
700 47 0113.A10 GB-I-E 20.02.2008 13:15 Uhr Seite 38