Filter
Top Products
26
Chapter 2 Installation
Connecting the Power Cable
1
Verify the power cable plug to make sure that it matches the AC IN
connector receptacle.
2
Make sure that the electrical outlet you use to connect the unit is properly
grounded.
3
Connect one end of the power cable to the AC IN connector and the other
end to the power outlet.
Note
If the S-AIT drive does not come with a power cable, make sure that you
connect a power cable appropriate for your country to this connector.
Installing Device Drivers
A device driver is host firmware that allows the S-AIT Tape Drive Unit to
interact with a variety of hosts.
If your software requires it, install the appropriate device driver for your system.
For details, contact your dealer.
The latest device drivers and documentation for the S-AIT Tape Drive Units are
available online. Contact your dealer for details or visit the Sony Web site
(http://www.sony.net/Products/storagesolution/).
If you are using a SDZ-S100 (SCSI model), proceed to “Connecting the SCSI
Bus Cable (SDZ-S100 only)” on page 27.
If you are using a SDZ-S130 (Fibre Channel interface model), proceed to
“Connecting the Optical Fiber Cable for Fibre Channel (SDZ-S130 only)” on
page 29.
AC Power