Filter
Top Products
60
GB
Error message
“ERR ACCESS“
“ERR DATA“
“FULL”
“LO BATT“
“NO DATA“
“NO ERASE”
“PRE SET”
“SET DATE”
For the error messages of the “Digital Voice Editor”, please refer to the
online Help files.
Cause/Remedy
•The IC recorder failed in memory access.
Remove and then insert the batteries.
•The file is not supported by the “Digital Voice
Editor” software, or the file itself is corrupted.
•The remaining memory of the IC recorder is too
small. Erase some messages before recording
(page 35).
•When there are already 99 messages in the
selected folder or the remaining memory of the
IC recorder is short, you cannot divide a
message. Erase some messages before dividing a
message (page 35).
•Batteries are weak. Replace batteries with new
ones.
•The selected folder does not have any messages.
You cannot set the alarm, etc. because of this.
•You cannot combine messages of different modes.
•You set the alarm to play back a message at a date
and time previously set on another message.
Change the alarm setting.
•If you do not set date and time, you cannot make
alarm or time recording setting. To set date and
time, see page 8.
Troubleshooting (continued)
Error Messages of the IC Recorder