Filter
Top Products
17
GB
Connecting the Projector
Setting Up and Projecting
On the USB function
When connecting the projector to a computer by using the USB cable for the
first time, the computer recognizes the following devices automatically.
1 USB hub (general use)
2 USB human interface device (wireless mouse function)
3 USB human interface device (projector control function)
Recommended operating environment
When you use the USB function, connect your computer as illustrated on page
16. This application software and the USB function can be used on a computer
loaded with Windows 98, Windows 98 SE, Windows ME or Windows 2000
preinstall models.
• Your computer may not start correctly when connected to the projector
via the USB cable. In this case, disconnect the USB cable, restart the
computer, then connect the computer to the projector using the USB
cable.
• This projector is not guaranteed for suspend, standby mode. When you
use the projector in suspend, standby mode, disconnect the projector
from the USB port on the computer.
• Operations are not guaranteed for all the recommended computer
environments.
To connect a Macintosh computer
To connect a Macintosh computer equipped with video output connector of a
type having two rows of pins, use a commercially available plug adaptor.
However, you can not control the mouse of the computer by the Remote
Commander.
This section describes how to connect the projector to a VCR and 15k RGB/
component equipment.
For more information, refer to the instruction manuals of the equipment you
are connecting.
Notes
Connecting with a VCR or 15k RGB/Component Equipment