Filter
Top Products
4
Getting Started Using Your Monitor
Preset and User Modes
This monitor will sync with any IBM or compatible system
equipped with VGA or greater graphics capability.
Although this monitor will sync to other platforms running
at horizontal frequencies between 30 and 85 kHz, including
Macintosh and Power Macintosh system, a cable adaptor is
required. Please consult your dealer for advice on which
adaptor is suitable for your needs.
Step 1: With the monitor switched off, attach the power
cord to the monitor and the other end to a power
outlet.
The Multiscan 20sfII has factory preset modes for the 10
most popular industry standards for true “plug and play”
capability.
For less common modes, the Multiscan 20sfII’s Digital
Multiscan Technology will perform all of the complex
adjustments necessary to ensure a high quality picture for
any timing between 30 and 85␣ kHz.
However, due to the wide variety of video boards on the
market, it may be necessary for the user to fine tune the
vertical/horizontal size and centering.
Graphics Mode
VGA Graphic
1)
VGA Text
1)
VESA
2)
Macintosh
16” Color
3)
VESA
2)
Macintosh
19” Color
3)
VESA
2)
VESA
2)
Macintosh
21” Color
3)
VESA
2)
Resolution
(dots × lines)
640 × 480
720 × 400
640 × 480
832 × 624
800 × 600
1024 × 768
1280 × 1024
1024 × 768
1152 × 870
1280 × 1024
Horizontal
Frequency
31.5 kHz
31.5 kHz
43.3 kHz
49.7 kHz
53.7 kHz
60.0 kHz
64.0 kHz
68.7 kHz
68.7 kHz
80.0 kHz
Vertical
Frequency
60 Hz
70 Hz
85 Hz
75 Hz
85 Hz
75 Hz
60 Hz
85 Hz
75 Hz
75 Hz
No.
1
2
3
4
5
6
7
8
9
10
Note: For Windows
® 4)
users, check your video board
manual or the utility program which comes with
your graphic board and select the highest available
refresh rate to maximize monitor performance.
Recommended horizontal timing conditions
Horizontal sync width should be: >4.8% of total horizontal
time.
Horizontal blanking width should be: >3.0 µsec.
1) VGA is a trademark of IBM Corporation.
2) VESA is a trademark of Video Electronics Standard
Association.
3) Macintosh is a trademark of Apple Computer Inc.
4) Windows
®
is a registered trademark of Microsoft.
Corporation in the United States and other countries.
Step 2: With the computer switched off, attach the video
signal cable to the video output.
Power cord (supplied)
to a power outlet
IBM or compatible computer
Apple computer
Step 3: Turn on the monitor and computer.
Step 4: If necessary, adjust the user controls according to
your personal preference.
The installation of your Multiscan 20sfII is complete. Enjoy
your monitor.
Note: Use HD15 (Female)-HD15 (Male without No.9 pin)
adaptor (supplied) for current DOS computer which
has no compliance of DDC 2AB and its No.9 pin is
disconverted.
to video output
Macintosh Adapter
(supplied)
to video output