Filter
Top Products
11
GB
Cleaning the Air Filter
6 Insert the new lamp all the way in until it
is securely in place. Tighten the two
screws. Fold up the handle.
• Be careful not to touch the glass surface of
the lamp.
• The power will not turn on if the lamp is not
secured properly.
• When attaching the lamp, be careful not to
overtighten the screws.
7 Close the lamp cover and tighten the
screw.
Be sure to attach the lamp cover securely as it
was. If not, the projector cannot be turned on.
8 Turn the projector back over.
9 Connect the power cord and turn the
projector to standby mode.
10Press the following keys on the control
panel in the following sequence for less
than five seconds: RESET, <, ,,
ENTER.
Do not put your hands into the lamp replacement
spot, or not fall any liquid or object into it to avoid
electrical shock or fire.
Disposal of the used lamp
For the customers in the USA
This product contains mercury. Disposal of this
product may be regulated if sold in the United
States. For disposal or recycling information,
please contact your local authorities or Electronics
Industries Alliance (http://www.eiae.org).
Cleaning the Air
Filter
The air filter should be cleaned whenever
you replace the lamp.
Remove all traces of dust from the outside of
the ventilation holes with a vacuum cleaner.
The time needed to clean the air filter will
vary depending on the environment and on
how the projector is used.
When it becomes difficult to remove the dust
from the filter with a vacuum cleaner,
remove the air filter and clean it.
1 Turn off the power and unplug the
power cord.
2 Place a protective sheet (cloth) beneath
the projector. Turn the projector over so
you can see its underside.
Be sure that the projector is stable after
turning it over.
3 Slide an air filter cover in the direction
of the arrow and remove it.
Notes
Note
Caution
Note