Filter
Top Products
16
Hardware Setup
CN5 - IR Connector
Attach a 5-pin infrared device cable to this connector for enabling the infrared
transfer function. This mainboard meets the specification of ASKIR and HPSIR.
CN2 - Keyboard Connector
A 5-pin female DIN keyboard connector is located at the rear of the board. Plug
the keyboard jack into this connector.
J17 - Keylock & Power LED Connector
J17 is a connector for a lock that may be installed on the system case for enabling
or disabling the keyboard. J17 also attaches to the case’s Power LED. (Pin 1,3 for
power LED and pin 4,5 for keylock.)
IDE1/IDE2 - Onboard Primary/Secondary IDE HDD Connectors
Attach cable of hard disk drives to these connectors.
CN1 - PS/2 Mouse Connector
Attach PS/2 mouse cable to this connector.
PRT - Parallel Port Connector
Attach parallel port cable to this connector.
PW - AT Power Supply Connector
The mainboard requires a power supply with at least 200 watts and a “power
good” signal. PW has two 6-pin male header connectors. Plug the dual connectors
from the power directly onto the board connector while making sure the black
leads are in the center.