Filter
Top Products
BIOS Setup Utility SY-6BA+ IV
83
3-8.5 Onboard Parallel Ports
Onboard Parallel
Ports
Setting Description Note
378H/IRQ7 Default
3BCH/IRQ7
Onboard Parallel
Port
278H/IRQ5
Choose the printer I/O
address.
ECP/EPP Default
SPP
ECP
Parallel Port Mode
EPP/SPP
The mode depends on your
external device that
connects to this port.
If [Parallel Port Mode] is set to [ECP] mode
3 Choose DMA3 Default
ECP Mode use
DMA
1 Choose DMA1
If [Parallel Port Mode] is set to [EPP] mode
EPP 1.9 Select EPP port type 1.9
EPP Mode Select
EPP 1.7 Select EPP port type 1.7 Default
On The system will switch on
when power comes back
after a power failure.
Off The system will remain off
when power comes back
after a power failure.
Default
PWRON After
PWR-Fail
Former-sts The system will return to
the state it was in before the
power failure when power
returns. (i.e: If the system
was on, it will switch on
again, if it was off, it will
remain off)