The ATA 66 Driver installation SY-6BA+ IV
94
Chapter 5
THE ATA 66 DRIVER INSTALLATION
Ø Installing the Windows 95/98 Drivers
Usually, when you boot up the Windows 95/98 system for the first time,
the system will be able to detect the HPT366 Ultra DMA host Adapter
automatically and ask you to install the driver for HPT366. You can just
follow the instructions promted by the system to install the driver. The
driver is located in the following directory:
D:\drivers\hp-ata66\Win9X (Where D is your CD-ROM driver letter)
Otherwise, you can install the driver by the following steps:
1. Windows 95/98 must be installed on the system prior to installing the
driver.
2. Close any running applications.
3. Open "My Computer".
4. Double click on the "Control Panel" icon.
5. Double click on the "Add New Hardware" applet.
6. Click on the "Next" button.
7. When asked "Do you want Windows to search for your new
hardware?", choose "No" then click on the "Next" button.
8. When asked to select the hardware type, select the "SCSI controllers"
and click on the "Next" button.
9. Make sure that the SOYO-CD is in your CD-ROM drive and click on
the "Have Disk..." button.
10. Select the D:\drivers\hp-ata66\Win9X directory (Where D is your
CD-ROM driver letter) and click on the "OK" button.
11. Click on the "Next" button.
12. If there is a window showing the settings (resources) to be used by
the driver, then click on the "Next" again. At this point, the system
will install the driver.