Filter
Top Products
SY-6BE+ Quick Start Guide
8
Hardware
Installation
Step 3. Configure Memory
Your board comes with three DIMM sockets, providing support for up to 768MB of main
memory using DIMM modules from 8MB to 256MB. For 66MHz front side bus CPUs use
12ns or faster memory; for 100MHz front side bus CPUs use 8ns (100MHz, PC100
compliant) memory.
Memory Configuration Table
Number of Memory Modules DIMM 1 DIMM 2 DIMM 3
1 1
st
2 1
st
2
nd
3 1
st
2
nd
3
rd
RAM Type SDRAM
Memory Module Size (MB) 8/16/32/64/128/256 Mbytes
Note:(1) 256 MB memory modules only available on PC registered DIMM.
(2) Always install memory modules in the order prescribed in this table.
(3) Do not install unbuffered and registered memory modules together.
Important:
It is of prime importance that you install DIMM modules as outlined in the table
above in order to preserve signal integrity on 100MHz front side bus systems.
Step 4. Set the CPU Frequency
This Motherboard does not use any jumpers to set the CPU frequency, CPU setting are
changed through the BIOS [SOYO COMBO SETUP]. Refer to Chapter 3 “Quick BIOS
Setup” for details on how to set the Slot 1 processor frequency.
Step 5. Enable/Disable Power-On by Keyboard (JP10)
You can choose to enable the Power-On by Keyboard function by shorting pin 1-2 on jumper
JP10, otherwise, short pin 2-3 to disable this function.
Power-On by
Keyboard
Enable Disable
JP10 Setting
Short pin 1-2 to enable the
Power-On by Keyboard function.
Short pin 2-3 to disable the
Power-On by Keyboard function.
Important: When using the Power-On by Keyboard function, please make sure the
ATX power supply can take at least 720mA load on the 5V Standby lead (5VSB) to
meet the standard ATX specification.
3
2
1
3
2
1