Filter
Top Products
SY-6VBA 133 Quick Start Guide
10
Hardware
Installation
Step 6. Set the CPU Frequency
You do not need to set any jumper for the CPU frequency. Instead, CPU settings are
changed through the BIOS
[SOYO COMBO SETUP].
Please refer to Chapter 3 - Quick
BIOS Setup for details on how to set the Slot 1 processor frequency.
Step 7. External Suspend Button (JP1)
Some cases come with a suspend button, insert the plug into JP1. In addition to this button,
the system can also enter the suspend mode through your OS.
Note: Suspend mode only functions if your Power Management mode is APM. Make sure that the BIOS
setting for Power Management is APM. Windows 98 can be installed with ACPI Power
Management (default is APM), in this case suspend mode will not function either.
Step 8. Enable/Disable Power-On by Keyboard (JP10)
You can choose to enable the Power-On by Keyboard function by shorting pin 1-2 on jumper
JP10, otherwise, short pin 2-3 to disable this function.
Power-On by
Keyboard
Enable Disable
JP10 Setting
Short pin 1-2 to
enable the
Power-On by
Keyboard function.
Short pin 2-3 to
disable the
Power-On by
Keyboard function.
Important: When using the Power-On by Keyboard function, please make sure the
ATX power supply can take at least 720mA load on the 5V Standby lead (5VSB) to
meet the standard ATX specification.
Step 9. 5V Stand-by indicator LED (LED 1)
This LED is lit whenever the 5V Standby voltage coming from the ATX powersupply is
available. If you have connected your ATX powersupply to the mains, LED 1 should be lit.
1
2
3
1
2
3