Filter
Top Products
SY-6VBA 133 Quick Start Guide
6
Hardware
Installation
Install the Motherboard
Follow the steps below in order to perform the installation of your new
SY-6VBA 133
Motherboard.
Step 1. Install the CPU
Mark your CPU Frequency:
Record the working frequency of your CPU
that should be clearly marked on the CPU cover.
FSB 66MHz
266MHz (66 x 4.0) 333MHz (66 x 5.0) 400MHz (66 x 6.0)
300MHz (66 x 4.5) 366MHz (66 x 5.5) 433MHz (66 x 6.5)
FSB 100MHz
350MHz (100 x 3. 5) 450MHz (100 x 4.5) 550MHz (100 x 5.5)
400MHz (100 x 4.0) 500MHz (100 x 5.0) 600MHz (100 x 6.0)
FSB 133MHz
400MHz (133 x 3.0) 533MHz (133 x 4.0) 666MHz (133 x 5.0)
466MHz (133 x 3.5) 600MHz (133 x 4.5) 733MHz (133 x 5.5)
CPU Mount Procedure:
To mount the processor that you have purchased
separately, follow these instructions.
Retention Module Step 1. Open the two sides by folding them up.
Step 2.
Push the locks on top of the CPU
inward.
Step 3. Insert the CPU into the retention
module. The CPU fits in the CPU slot in
only ONE way, do not try to force it in.
Step 4. After completely
inserting the CPU,
push the two locks
on top of the CPU
outward. Now
your CPU is ready
for use.
To remove the CPU,
press the two notches
on top of the CPU
inward. Now press the
two slides on the
retention module down
and remove the CPU.